omni
fmca
Roller Boat

Roller Boat from Rollerboat

2810 COOPERS LANE SELLERSBURG, IN 47172

Company Profile

How the Hull is Built

The hull is built in-house by Destination Yachts and carries a 5 year warranty.

Each side and every 5 feet of hull has an air tight compartment. This leaves the center open for the drive rollers and extra storage and it also avoids potential disadvantages associated with some full hull boats. During construction, each air tight compartment is pressure tested, as pressure is applied, all welds are soap tested, looking for any possible defect.

The center of the deck is reinforced from the bow back to the rollers to support the heaviest of motor homes. Ballast tanks are built into each corner to allow the boat to take on weight (water) allowing the boat to compensate for the uneven loads.
How the Steering System Works

The fly-by-wire steering system is an electric controlled hydraulic power steering system. The controller will be permanently mounted on a box which can be moved from RV to RV and temporarily attached to the RV steering wheel. It will be connected to the 12 volt boat power supply by cable.

When the system is powered up, the driver can move the toggle atop the controller either left or right. This action activates a motor which drives a hydraulic pump. There is a steering cylinder attached to the stern drive at the transom. Depending on which way the toggle was moved, the cylinder rod will either extend or retract, turning the stern drive either left or right. Moving the toggle to the center detent will return to straight forward.
How the Drive Train Works

The drive train consists of a pair of rollers for the left and the right motor home drive wheels. The rear rollers are the power rollers and the forward are the idler rollers, used only to keep the motor home cradled. Power is transferred from the motor home to the power rollers, then through a differential and out to a driveshaft connected to the stern drive . Whatever control put into the motor home, (accelerator, forward and reverse), is transferred directly to the stern drive. Reverse is also the brake. Steering is accomplished through a separate electric system.
How the Rollerboat is Loaded

Loading the motor home onto the Rollerboat is simple and safe. To do this, the bow is secured against the cement boat launch ramp with mooring lines, a small portable loading ramp is attached to the bow and then the motor home is backed on and into place. The ramp is removed, the mooring lines are untied and Rollerboat is ready to cruise.
Driving the Rollerboat

There is very little difference between land and water driving. Forward and reverse are the same as is the accelerator. Steering and braking are the main differences between land and water, that and the fact it is so much more relaxing. There are no traffic lights, no hills to climb, no traffic cops, just you, your good company and the quiet waters.
see

YOU MIGHT ALSO BE INTERESTED IN

OTHER Product ShowcaseS

You have set your region to SELECTED REGION

x close menu